wallpaper Today I hyperfocused on the baby afghan again. Worked six 36 inch rows in pretty much one sitting while watching two movies and three Heroes season 4 episodes. The two movies were Spiderman 2 and Air Bud Golden Receiver. I was hoping to make up for some of the the quota that didn't get done during Bloggiesta this past weekend and the library visit yesterday. I was behind by ten rows. Since the first four rows I did today count for today's quota only, I've made up only two rows.
I think I better lighten up tomorrow though and probably should stop altogether tonight. When I was dishing up my dinner tonight I almost dropped the serving bowl and I was nearly holding my breath all through doing dishes for fear of dropping something breakable. For my thumb and index finger and wrist on my right hand were not dependable and an electric sizzle shot up the inside of my left arm from pinky to armpit every time I raised it above the level of my lowest rib. The uncooperativeness of my right hand was not a surprise but that sizzle in my left arm was quite disconcerting. Apparently holding the growing afghan steady at the right distance is as demanding on the physical structure of the arm as is plying the hook itself.
The afghan is now bulky enough to be be in my way as I work on it which is a problem with no obvious solution. The thread is constantly getting trapped under it or in the folds. I now have 95 36 inch rows. I'm aiming for 155. It is now 36 X 18 inches.
Watch for a picture on Thursday for the end of week 4 progress report.
BTW I learned yesterday that my niece may be bringing the baby this way in late February. So I am highly motivated to have the afghan finished by then. If I can maintain the pace getting the rows done should be no problem. I'm concerned abou the fringe though. There are to be 150 or so per side and I have no idea how long that will take. I was planning to fringe all four sides but am now considering doing only the two sides where the rows begin and end which is where the start and finish thread tails are. I'll decide after I've got most of one side done which will give a better idea of the time involved.
